Reagentless system for sulphite determination based on polyaniline

A new reagentless system for sulphite (or sulphur dioxide) determination is reported based on the use of an organic conducting polymer, polyaniline, and its absorbance variation at 550 nm, depending on the sulphite concentration. After chemical polymerisation of aniline a very thin film of polyaniline is obtained. Although the response is not fully reversible, each film can be used for at least 10 measurements for low analyte concentrations (up to 0.5 mg l⁻¹) and five measurements for higher sulphite concentrations. Moreover, the reproducibility, ease of preparation and low cost of the films, permit the use of a new disposable system for each measurement. When the change in absorbance at 550 nm was measured for 210 s (stabilisation time), the system showed a linear response, which ranged from 0.025 to 1.50 mg l⁻¹ of sulphite. A theory with regard to the reaction mechanism between the polyaniline films and sulphite is also proposed. The system was applied to sulphite determination in wine samples and the results were in agreement with those obtained by the Official Method of Analysis (iodometric titration).     

Intermolecular hydroamination and hydroarylation reactions of alkenes in ionic liquids

Intermolecular hydroamination or hydroarylation reactions of norbornene and cyclohexadiene performed with catalytic amounts of Brönsted or Lewis acid in ionic liquids were found to provide higher selectivity and yields than those performed in classical organic solvents. The ionic liquid increases the acidity of the media and stabilizes ionic intermediates through the formation of supramolecular aggregates.     

Self-interaction-corrected electronegativities and hardness for atoms

Electronegativity χ and hardness η for 54 atoms and their positive and negative ions are calculated by means of self-interaction-corrected DFT including correlation terms. The exchange potential energy is treated by local spin density approximation corrected to account for self-interaction effects as suggested by Rae. The highest occupied orbital eigenvalues for ions are identified to the chemical potential μ^± for positive and negative charged atoms depending upon the developing charge process. Values of χ^±δ and η^± for the different ionic species are given for several values of δ. Average values for 〈χ〉 and 〈η〉 in the sense of Mulliken finite formula for neutral atoms are also tabulated and compared with Mulliken values from experimental data. The agreement among them is almost quantitative.     

Use of NIRS technology with a remote reflectance fibre-optic probe for predicting major components in bee pollen

In the present work, we study the use of near infra-red spectroscopy (NIRS) technology together with a remote reflectance fibre-optic probe for determination of the major components in bee pollen. The method allows immediate control of the bee pollen without prior sample treatment or destruction through direct application of the fibre-optic probe to the sample.The regression method employed was modified partial least squares (MPLS). The calibration results obtained using 45 samples of bee pollen allowed the measurement of protein, moisture, ash, reducing sugars, and pH with multiple correlation coefficients (RSQ) and prediction corrected standard errors (SEPC) of 0.91, 0.56% for protein, of 0.78 and 0.49% for moisture; 0.92 and 0.049% for ash; 0.81 and 1.32 g of glucose/100 g of bee pollen; 0.84 and 0.15 for pH, respectively.The prediction capacity of the pattern was checked by applying it to samples of unknown pollen in external validation.     

Joint QTAIM and Hirshfeld study of the sigma and pi charge distribution and electron delocalization in carbonyl compounds: a comparative study with the resonance model

Atomic charges and delocalization indexes (DIs) for a series of carbonyl compounds comprising dimethyl ketone, acetaldehyde, acetic acid, methyl acetate, acetamide, methyl vinyl ketone, divinyl ketone, and benzoic acid were studied using two different atomic partitionings: the QTAIM and the Hirshfeld (stockholder) scheme. The resonance model, traditionally employed to explain the reactivity of these compounds, is not in line with the total atomic charges and DIs calculated by both methodologies. However, the resonance model is supported to some extent by the pi charges and pi DIs calculated by both schemes, but the calculated values indicate that the pi population delocalizes only to a small degree. Although the absolute values of QTAIM and stockholder atomic charges are significantly different, the pi charges and the values of the DIs show similar trends for all the atoms and molecules of this study; this is especially the case for the pi DIs. A study of the electron density on the level of a single MO performed for CO, H2CO, F2CO, and H2CS reveals that the differences in the atomic sigma charges computed with both partitionings can be traced back to their different treatment of interatomic regions.     

Electrospray ionization mass spectrometry fingerprinting of whisky: immediate proof of origin and authenticity

Authentic samples of whisky produced in Scotland and USA and counterfeit whisky samples commercialized in Brazil have been directly submitted to electrospray ionization mass spectrometry (ESI-MS) analysis in both the negative and positive ion modes to assess the potential of this technique for simple and rapid quality control and proof of authenticity of whisky samples. ESI in the negative ion mode yields the most characteristic whisky fingerprinting mass spectra in just a few seconds by direct infusion of the samples, detecting the most polar or acidic components of each sample in their deprotonated anionic forms. No pre-treatment of the sample, such as extraction or derivatization or even dilution, is required. The analysis of the ESI(-)-MS data both by simple visual inspection but more particularly by chemometric data treatment enables separation of the whisky samples into three unequivocally distinct groups: Scotch, American and counterfeit whisky, whereas single malt and blended Scotch whiskies are also distinguished to some extent. As indicated by ESI-MS/MS analysis, the diagnostic anions are simple sugars, disaccharides and phenolic compounds. Direct infusion ESI-MS therefore provides immediate chemical fingerprinting of whisky samples for type, origin and quality control, as demonstrated herein for American, Scottish and counterfeit samples, whereas ESI-MS/MS analysis of diagnostic ions adds a second dimension of fingerprinting characterization when improved selectivity is desired.     

Minor diterpenoids from Halimium viscosum

Two new diterpenic acids with an ent-halimane skeleton have been isolated from the aerial parts of Halimium viscosum (Villarino de los Aires chemotype) and separated as methyl esters. These diterpenes were 13-oxo-14, 15-dinor-1(10),11E-ent-halimadien-18-oic acid and 15-hydroxy-1(10),13Z-ent-halimadien-18-oic acid.     

Combined cysteine and homocysteine quantitation in plasma by trap and release membrane introduction mass spectrometry

Recently, a new and efficient method for total homocysteine (tHcy) quantitation in plasma using trap and release membrane introduction mass spectrometry (T&R-MIMS) with a versatile removable direct introduction membrane probe (DIMP) was described [R. Haddad, M. A. Mendes, N. F. Hoehr and M. N. Eberlin, Analyst, 2001, 126, 1212]. Herein we report on the use of the DIMP-T&R-MIMS technique for total cysteine (tCys) quantitation; hence combined tCys and tHcy quantitation in plasma or serum can be achieved. The method employs Cys and Hcy derivatization with ethyl chloroformate (after disulfide bond reduction with dithiothreitol and protein precipitation with trichloroacetic acid), preconcentration in a capillary silicone membrane, and their thermal desorption to the gas phase inside the ion source region of a mass spectrometer, at a point exactly between the two ionization filaments. Thermal desorption uses the uniform heat radiation provided by the two ionization filaments. The analytes are then ionized by electron ionization and both Cys and Hcy are quantitated by mass spectrometry using selected ion monitoring. For tCys quantitation, good linearity and reproducibility was observed for concentrations ranging from 5 to 350 microM, recovery was near 95%, and the limit of detection (LOD) was of 2 microM. This LOD is well below the mean Cys concentration in plasma, and serum samples from a large group of healthy people showed a mean tCys concentration of 132 +/- 45 microM.     

Sequence-dependent conformational energy of DNA derived from molecular dynamics simulations: toward understanding the indirect readout mechanism in protein-DNA recognition

Sequence dependence of DNA conformation plays a crucial role in its recognition by proteins and ligands. To clarify the relationship between sequence and conformation, it is necessary to quantify the conformational energy and specificity of DNA. Here, we make a systematic analysis of dodecamer DNA structures including all the 136 unique tetranucleotide sequences at the center by molecular dynamics simulations. Using a simplified conformational model with six parameters to describe the geometry of adjacent base pairs and harmonic potentials along these coordinates, we estimated the equilibrium conformational parameters and the harmonic potentials of mean force for the central base-pair steps from many trajectories of the simulations. This enabled us to estimate the conformational energy and the specificity for any given DNA sequence and structure. We tested our method by using sequence-structure threading to estimate the conformational energy and the Z-score as a measure of specificity for many B-DNA and A-DNA crystal structures. The average Z-scores were negative for both kinds of structures, indicating that the potential of mean force from the simulation is capable of predicting sequence specificity for the crystal structures and that it may be used to study the sequence specificity of both types of DNA. We also estimated the positional distribution of conformational energy and Z-score within DNA and showed that they are strongly position dependent. This analysis enabled us to identify particular conformations responsible for the specificity. The presented results will provide an insight into the mechanisms of DNA sequence recognition by proteins and ligands.